Anti static measures are important in cleanroom purification engineering, as static electricity can attract dust and other small particles, leading to a decrease in cleanliness. The following will provide a detailed introduction to anti-static measures in cleanroom purification engineering.
1. Ground materials
2. The floor of the clean room should use anti-static flooring materials, such as organic glass, PVC, rubber, polyester resin, etc., which are commonly used flooring materials. These materials have the characteristics of poor electrical insulation, strong conductivity, hardness and flatness, and do not produce volatile substances, which can effectively prevent the generation of static electricity on the ground.
Ground treatment
In addition to using anti-static flooring materials, floor treatment is also an important measure for anti-static. The floor of the clean room should be kept dry and clean to reduce the generation of static electricity. It is recommended to lay carpets or aluminum foil with good conductivity on the ground to increase its conductivity.
3. Personnel anti-static measures
Personnel are also a key factor in preventing static electricity generation. Before entering the clean room, personnel should wear anti-static clothing or shoes to reduce or eliminate human static electricity. After entering the clean room, personnel must follow the prescribed operating procedures and avoid touching the ground or other substances.
4. Equipment anti-static
Equipment in cleanroom purification engineering also needs to take anti-static measures. The equipment should be made of materials with good conductivity to prevent static electricity. Equipment grounding is also very important, and the grounding status of the equipment should be continuously checked to ensure good grounding.
5. Air purification
The impact of static electricity on clean room purification is transmitted through the air, therefore, air purification can also effectively reduce the influence of static electricity. Sufficient quantity and variety of static eliminators should be equipped in the air. The types of static eliminators include charged rods, static brushes, static lamps, etc., which can effectively reduce static electricity in the air.
Anti static clothing is a special type of clothing used to reduce human potential in places with static electricity and avoid other hazards caused by high potential on clothing. It is widely used in oil fields, chemicals, electricity, military and police, racing cars, firefighting and other occasions with special requirements for clothing performance. Anti static clothing is suitable for dust-free, static sensitive areas, and general purification areas. Anti static clothing is made of stainless steel fiber, sub conductive fiber, anti-static synthetic fiber, and polyester cotton blend or mixed fabric, which can automatically discharge or leak discharge, eliminating the charge on clothes and human body. At the same time, anti-static hats, socks, and shoes are also made of the same material.
1. In places where explosive gas mixtures occur continuously or frequently for a period of time or exist for a long time under normal circumstances, as well as places where explosive gas mixtures may occur, and where the minimum ignition energy of combustibles is below 0.25mJ, electrostatic protective clothing should be worn. 2. It is prohibited to wear or remove anti-static protective clothing in flammable and explosive places. 3. It is prohibited to attach or wear any metal objects on electrostatic protective clothing. 4. When wearing anti-static protective clothing, it should also be used in conjunction with anti-static shoes, and the ground should also be a conductive floor. 5. Static protective clothing should be kept clean and have anti-static properties. After use, use a soft bristled brush or cloth dipped in neutral detergent to scrub without damaging the fabric fibers. 6. After wearing for a period of time, static electricity protective clothing should be inspected. If the anti-static performance does not meet the standard requirements, it cannot be used as static electricity protective clothing anymore
Suzhou Pharma Machinery Co.,Ltd.
2024/09/02
Gino




