pharma@sz-pharma.com    +86-18241958031
Cont

Have any Questions?

+86-18241958031

Jun 19, 2024

Filtration Unit Fan Components

Lightweight models can be a good option for this stage. After installation, a motor-driven fan is started, which circulates air through the filtration system. This way, by removing 99.99% of all pollutants, the air is purified. The structural components of the filtration unit fan are as follows:

  • Housing: The filtration unit fan housing is made of galvanized steel, powder-coated steel, or SUS 304 stainless steel. It is worth mentioning that the housing material can also be selected according to customer needs. The housing thickness is about 1.2 to 2.0 centimeters.

 

  • Pre-filter: The main function of the pre-filter is to prevent damage to the HEPA filter caused by debris.

 

  • Fan: The fan sucks in air and blows it towards the HEPA filter.

 

2FFU

 

  • Filter: The filter used for the filtration unit fan is a HEPA or ULPA filter. In fact, it can be said that the most important part of the filtration unit fan is its filter, which filters the air and creates a fresh and clean environment.

 

  • Controller Switch: The filtration unit fan is equipped with a three-level switch for speed control and an on/off switch, and there are three levels (low, medium, and high) for air speed control.

 

  • Motor: AC and DC motors can be used. Of course, the DC motor is large and expensive, but it is easy to control. Some high-quality motors are lubricated without oil. These motors have sealed bearings, are equipped with thermal overload protection, and have a long service life.

 

  • Air Duct Connection Parts: In cleanrooms with a low cleanliness level, there is no static pressure on the ceiling. Thus, the air duct connection parts make the connection between the air duct and the filtration unit fan easier.

Send Inquiry